Page 1 of 1
stamp in place for multiple frames
Posted: 19 Nov 2012, 09:43
by ryberg
I'd love it if you could use enter to repeatedly re stamp in place with the cutbrush or if you could select multiple frames and stamp in place
Re: stamp in place for multiple frames
Posted: 19 Nov 2012, 10:49
by Paul Fierlinger
For that I use this key command combo:
Tools: Draw Dot+Layer: Next Image
Re: stamp in place for multiple frames
Posted: 19 Nov 2012, 11:40
by ZigOtto
ryberg wrote:... or if you could select multiple frames and stamp in place
it works here,
if your sequence is already timed (exposed), make a custom button with these 2 commands :
Code: Select all
Tools: Re-Apply Custom Brush
Layer: Recompute Exposures
Re: stamp in place for multiple frames
Posted: 19 Nov 2012, 12:16
by slowtiger
arrow, enter, repeat?
Re: stamp in place for multiple frames
Posted: 19 Nov 2012, 14:50
by ryberg
ZigOtto wrote:ryberg wrote:... or if you could select multiple frames and stamp in place
it works here,
if your sequence is already timed (exposed), make a custom button with these 2 commands :
Code: Select all
Tools: Re-Apply Custom Brush
Layer: Recompute Exposures
doesn't "Re-Apply Custom Brush" need you to stamp the brush once in order to re apply or is it simply stamp in place right after you cut it out?
and, yeah, I also need to recompute my instances even though auto create instance is switched off.
Re: stamp in place for multiple frames
Posted: 19 Nov 2012, 15:09
by ZigOtto
ryberg wrote:...
doesn't "Re-Apply Custom Brush" need you to stamp the brush once in order to re apply or is it simply stamp in place right after you cut it out?
make the 2 commands button mentioned above and try it ... you'll get the answer by yourself !
in fact, no, "Re-Apply Custom Brush" applies it at its original place (at least it's how it works here), doesn't need to be applied once before.
btw, what's your tvpa version ?
Re: stamp in place for multiple frames
Posted: 19 Nov 2012, 15:38
by ryberg
well, it seem like I created some confusion since I'm using one of Juuls Actions to stamp in place which includes a smart function for the smoothing of the cutbrush. That action can not be applied to several selected frames.
I can do that if I simply hit the stamp in place under the cutbrush options or create an action like ZigOtto suggested. Thanks for that.
What I was aiming for in the first place though, was for enter to work as re apply for stamp in place as well.