little problem with Project Timeline

[sandriko]

hi
i just wanted film duration to be shown in min/sec instead of frames in project timeline..
i`ve searched alot but without any result

maybe some of you know about it smth?

thx!
sandriko

[Paul Fierlinger]

That would then be Time Code. To switch from Frame to Time Code, go to the extreme left bottom of the Layer Panel.

[ZigOtto]

you can also assign a hotkey to [Layer: Toggle Frames/Time Code] command, via the Preferences/ShortCuts/Configure panel .

[sandriko]

ooh thank you so much, sometimes i`m getting a bit confused about all these buttons around.
buti don`t think that it`ll be necessary to assign it to hotkey cause it isn`t everyday hotkey tool (for me)

thank you very much!

[Retablez]

I am looking for that switch on TVP 10, but I can't find it in the place you describe. To my knowledge, it seems that timecode can be activated or deactivated on the preferences panel.

[Paul Fierlinger]

Unfortunately that switch in the bottom corner of the layer panel has been since removed -- the only way is to either create a custom button or assign a key for the command. I have a custom button made with this command:
Key: Timeline: Toggle Frames/Time code.