How do I toggle the visibility of the crosshair

jingles11 · Post by **jingles11** » 11 Apr 2009, 22:02

I have tried very hard to figure this out and I can't do it. I don't want to see a crosshair I just want to see the circle of the brush, somehow I turned it on by accident and I have been trying for hours to figure out how to get rid of it.

Sewie · Post by **Sewie** » 11 Apr 2009, 22:35

Edit > preferences, you'll find the cursor options under the interface tab.

Paul Fierlinger · Post by **Paul Fierlinger** » 12 Apr 2009, 01:12

Or a key command which you can turn into a button if you want:
Key: Interface: Next Cursor
With this you can rotate through the cursors from the GUI; quite handy

jingles11 · Post by **jingles11** » 12 Apr 2009, 07:47

I could have sworn, and I can see in some little visuals on the website, that you can have no cursor at all. The small dot is acceptable though. It was driving me nuts and seemed so simple and stupid. I went through the same thing in Photoshop not knowing about caps lock and I had to ask a guy. Thank you guys.

Welcome to TVPaint Community forums !

How do I toggle the visibility of the crosshair

How do I toggle the visibility of the crosshair

Re: How do I toggle the visibility of the crosshair

Re: How do I toggle the visibility of the crosshair

Re: How do I toggle the visibility of the crosshair