TVP12 Copy/Cut to Layer Bug when No Camera Layer present [TVPA-3654]

[Cardin]

TVP12 adds new layer to BOTTOM of layer stack instead of Above the current layer under the following conditions:

1) No Camera Layer in the project
2) Selection is made from the topmost layer.

TVP12 Copy-Cut to New Layer Bug.mp4

(21.11 MiB) Downloaded 177 times

[Peter Wassink]

Was gonna say, change it in the "new layer presets" panel...
but it turns out this is already set to "new layer - above"!?

So yes, another bug

[Léo]

Hello Cardin,
Bug confirmed on our side, devs are on it. Thank you for this feedback !