bug: export panel ignores both the in/out point markers and the selection

[Peter Wassink]

When exporting why does TVPaint ignore both the selected frames AND the in out marks?

i tried setting in/out markers, both activated and not activated, but they are ignored
and i tried selecting a range of frames, but this was also ignored.
so do i have to manually set the mark in and out AGAIN in the Export footage panel?

[Peter Wassink]

# edit....

i found that if you select a range you can click on the circle arrow symbols next to the mark buttons in the export panel..

a bit unintuitive, i would think it should per default follow the mark in and out of the project, when set?

[Paul Fierlinger]

That was shot down by several users including myself. I'd hate to have to remember each time I export a project to turn off the markers. Also markers are often shifted around in the animation process and I like to find these where I last used them when I return to TVP. In the rare cases I would like to export less than the complete project I change the in and out frame numbers in the export panel.

[Xavier]

Hi, could you please explain precisely what you'd like to have ?

From what I understood:
- by default, export the full project (no markin and markout)
- automatically set the markin and markout, based on the selected instances

What about a checkbox, that you'd have to untick to set the markin and markout ?

export.png (95.11 KiB) Viewed 8187 times

[Paul Fierlinger]

The check box sounds the most reasonable to me, if I understand the options properly. The way I understand this is that someone like me who doesn't like to have the mark in and out placements reflected in the export panel but on the rare occasions when I need to have them visible I would uncheck the box. Is that correct? And by the same token, anyone who wants their mark ins and outs reflected during export would keep their check box unchecked

[Xavier]

yes, that's what I meant